Water supply is the first question we ask on a Indianola job. Kitsap PUD operates the Indianola water system for the village and the surrounding neighborhoods. Some outlying parcels toward Miller Bay and Gunderson Road are on private wells. From our shop in Port Orchard, Indianola is about 45 to 55 minutes from Port Orchard by Highway 3, Highway 305 and Indianola Road; we schedule it alongside nearby stops so windows stay tight.
Why whole-house repiping is a little different in Indianola
Waterfront and hillside homes around Indianola tend to have been added onto over the decades, with supply lines that wander through every addition. A repipe is the chance to shorten the runs, bring hot water to the far bathroom faster, and add a recirculation line if the layout calls for it.
Where the drains end up matters just as much. Indianola has no public sewer. Every home, from the small village lots near the dock to the acreage along Gunderson Road, is on septic. The small beach lots in the village often rely on pumped systems.
Local conditions that affect whole-house repiping in Indianola
Here is a Indianola detail that changes how we approach the job: Water heaters undersized for cottages that became full-time homes
Many Indianola homes were built when galvanized steel was the standard, and those lines are now choked with rust on the inside. The slow pressure fade is so gradual that owners get used to it. A PEX repipe restores the pressure the house had when it was new, and the difference at the shower on the first evening is usually the moment people stop second-guessing the decision.
The pattern we see most in Indianola is this: Frozen and burst pipes in vacation cottages left unheated in a cold snap
Crawlspaces around Indianola are damp through the rainy season, and we often find old supply lines lying in dirt or standing water under the house. New PEX is strapped to the joists, kept off the ground, and insulated near the vents. While the crawlspace is open we look at the drains, too, and point out anything worth doing at the same time.
Signs Indianola homeowners call us for whole-house repiping
Worth a call
- Fixture shutoff valves that will not close or break when turned
- Hot water takes several minutes to reach the far bathroom
- A home inspection flagged the supply piping before purchase
- A freeze split pipes in several places at once
- Pressure drops to a trickle when a second fixture is turned on
How we handle whole-house repiping in Indianola
A typical whole-house repiping visit in Indianola follows the same shape: walkthrough and route plan, one flat price, material chosen, day one: main, kitchen, water heater, day two: remaining fixtures, pressure test, flush, inspect, then clean up and hand over. The price is approved on your phone before step two begins.
Read the full step-by-step for whole-house repiping →
Indianola neighborhoods and areas we serve
Our Indianola work runs from Gunderson Road across to Indianola Road, and out around Indianola Country Store and Port Madison Bay and the view toward Seattle. Anywhere inside the Kitsap County side of our territory is fair game.
Whole-House Repiping questions from Indianola
Will a repipe fix my low water pressure in Indianola?
If the cause is galvanized pipe, yes, completely. If pressure is low because of elevation or a long service line from a well or meter, we will say so during the walkthrough and talk about a booster pump instead of selling you a repipe you do not need.
How long will a repipe take in my Indianola home?
Most single-story homes in Indianola are done in two days with water restored each evening. Two-story homes and those on a slab typically take three. You stay in the house throughout.
Do you use PEX or copper for repipes in Indianola?
PEX on most jobs, with copper at the water heater and anywhere exposed to sunlight. We quote a full copper repipe as well if you prefer it or your situation calls for it.
How much wall damage should I expect?
Less than people fear. On a crawlspace home in Indianola, openings are mostly limited to the tub and shower valve walls. We mark every planned opening before you approve the price, and we leave them square for easy patching.
Will you have to tear up all my walls?
No. On a crawlspace home most of the new pipe runs under the floor and comes up through existing holes. Openings are needed behind tub and shower valves and sometimes at a second-floor bathroom. We mark each one before you approve the job.
Greg started this company to do plumbing the way he would want it done at his own house: show up when promised, explain the options, and leave the place clean. That is what Indianola homeowners can expect from us.