Water supply is the first question we ask on a Union job. Mason PUD 1 runs several community water systems in the Union area, including Vuecrest and systems tied to Union Ridge, and other shoreline communities have small association systems. Outlying properties are on private wells. No city water. It is about 50 minutes from Port Orchard, west on Highway 3 to Belfair and then Highway 106 along the South Shore of Hood Canal to Union, a run we make often enough to know the roads, the water districts and the quirks of the housing.
Why water heater installation & replacement is a little different in Union
Seismic strapping is required on every water heater in Washington, and a surprising number of Union heaters we replace have none. The new unit is strapped into framing at the top and bottom.
What happens past the house is not the same across Union. Septic. There is no public sewer in Union or along the South Shore; the Alderbrook area has its own on-site treatment. Shoreline lots along Highway 106 typically pump effluent uphill across the road to a drainfield.
Local conditions that affect water heater installation & replacement in Union
Here is a Union detail that changes how we approach the job: Backflow preventers and irrigation on the larger waterfront properties
Fuel determines the heater in Union. Where natural gas or propane is available, a gas tank recovers faster and costs less to run; in all-electric neighborhoods a standard electric heater is simple and dependable. We check what serves your address before quoting.
The pattern we see most in Union is this: Freeze damage in seasonal cabins and exposed hillside lines
Older Union homes often have the water heater in a crawlspace or a tight closet. We measure the access door and headroom before ordering so the unit we bring is the unit that fits.
Signs Union homeowners call us for water heater installation & replacement
Worth a call
- Loud rumbling that flushing no longer cures
- Water at the base of the heater with no fitting above it
- Rust streaking from the tank jacket or rusty hot water
- The heater is past a decade old and needs an expensive repair
- Hot water runs out before the household is done showering
How we handle water heater installation & replacement in Union
A typical water heater installation & replacement visit in Union follows the same shape: size and fuel on the phone, measure and confirm access, remove and set the new heater, fuel, vent and fill, then test and walk through. The price is approved on your phone before step two begins.
Read the full step-by-step for water heater installation & replacement →
Union neighborhoods and areas we serve
Whether you are near The Great Bend of Hood Canal and Dalby Waterwheel or further out toward Skokomish Valley edge or South Shore Road east toward Twanoh, Union addresses get the same arrival window and the same flat price.
Water Heater Installation & Replacement questions from Union
What size water heater does my Union home need?
It depends on household size, fixtures and schedule. We ask a few questions and recommend a size, and if space is tight we can add a mixing valve to stretch a smaller tank.
Do you handle the permit for a water heater in Union?
Yes. The permit and inspection are part of the job, and the record comes with your invoice.
Can you install a gas water heater in Union if I have propane?
Yes. Propane models are available from the brands we install, and we set up the regulator and drip leg correctly for propane.
Will you take away the old water heater from my Union house?
Yes. Haul-away and recycling are included in the flat price.
Do I need an expansion tank?
If your home has a pressure reducing valve or a backflow preventer at the meter, which most homes on municipal water around here do, yes. It is required by code and it stops the relief valve from dripping. We include it in the quote.
Greg is a veteran who built this company on showing up when he says he will. For Union homeowners used to waiting days for a callback, that alone is a change.